Equipments for metallic of SPRAYMAQ, Discover the best prices to obtain the best process of metallic paint can. If you wish you can call us using the number listed at the top of the screen and our commercial team will assist you to be happy! In addition, You can visit us at Bilbao, Zaragoza and Madrid Since already!
Thermal Spray processes
Thermal spraying is a cost-effective method to improve the properties of surfaces. We have different thermal imaging or metallizing equipment, with different options to adapt to its surface and all other requirements of your application.
Wire arc spraying
Using electric arc wire spraying, offering an excellent portability for coatings in any place. It covers weld of pipe applications, piston rings, capacitors, Varistors, walls of the boiler, and major infrastructure. Uses only electricity and atomized air to melt the metal alloy and pure metallic wires.
Description of the process
For the projection of wire for electric arc process, We use two metal wires, typically of the same composition, as the raw material coating. The two wires are electrically charged with the opposite polarity and entered into arc in paired gun, controlled speed. When we bring the wires together at the point of contact, loads opposite on cables create enough heat to continuously melt the ends of the wires. We use compressed air to atomize the already melted material and speed it up to the surface of the workpiece to form the coating.
Elements of processes
| Heat source | Plasma arc |
| Material | Wire |
| Temperature arc | Approx.. 4000 ° C |
| Speed of the particles | Approx.. 150 m / s |
| The performance of the spray | 15 – 3300 g / min |
Schematic diagram of an electric arc wire process.
Key features
- Excellent portability for coatings on the site
- It does not require any water or gases except compressed air process
High rates of spray
Typical applications
- Spans for bridges
- Pipelines conveying
- Capacitors
- Seam welded pipe
- Piston rings
- Varistors
- Walls of the boiler
- Other major infrastructure
Combustion wire spray
Our spray combustion wire services include three-dimensional surface restoration and anticorrosive coatings. Based on metal cables are used in the workshop or in the place for the coating of large metal structures, chemical and petroleum tanks, and marine applications.
Description of the process
We eat continuously the sprayed material in the form of wire in a gas flame of oxygen fuel where is melted by the heat of combustion. Compressed air surrounds the flame and atomizes the melted tip of the wire. This accelerates the Jet of particles fused to the surface of the prepared piece. Spray combustion wire is a common choice for repair of element of the machine and corrosion Coatings. You have the option of disk (higher melting temperature) or (lower melting temperature) soft wires.
Elements of processes
| Heat source | Fuel and oxygen |
| Material | Wire (Metal) |
| Flame temperature | Approx.. 3100 ° C |
| Speed of the particles | Up to 200 m / s |
| The performance of the spray | 15 – 1400 g / min |
Schematic diagram of a combustion process of wire.
Key features
- Portable for coatings on the site
High rates of spraying with low gas consumption
Typical applications
- Steel structures
- Pipelines conveying
- Storage tanks
Another type of equipment for paint related:
- Liquid paint equipment.
- Powder coating machines.
- Air compressors to paint.
- Air filters to paint.